RF Face Lifting Skin Spa System skin microdermabrasion machine

RF Face Lifting Skin Spa System skin microdermabrasion machine

How it works?

With the diamond grains in heads, DERMABRASION MACHINE w/9 HEADS, through vacuum suction, grind the dead horniness and dirt out from epidermis, improve skin status, effectively decrease tiny wrinkles, smoothen some scar like acne and uneven surface of skins. It makes skin more velvet and tender, stimulate epidermis rebirth, enhance skins elastic. It is the safest, most effective way of physical skin renewal.

Function

1) Cleansing the deep-layer skin, removing the dead surface-layer skin and the thicker horniness;
 

2) Resolving the grease and removing pimple and macula;
 

3) Desalinating pigment and improving the old-aged spot;
 

4) Promoting the metabolism and blood circulation, and activate the skin;
 

5) Promoting rebirth of the collagen and spring fiber, and removing fine wrinkle and gestation wrinkle;
 

6) Increasing the absorption ability of skin for 5-10 times than the original;

Notice

1. Always begin treatment conservatively and observe the effects by the touch and appearance of the skin. A vacuum power that is too high or too big may cause an inflammatory response.

2. Edema and erythema can occur following treatment, but will resolve in few hours.

3. Overly aggressive techniques can cause mild flaking over the next 3-4 days. Epidermis that is treated too aggressively can lead to bleeding in the superficial dermis.

4. Diamond Dermabrasion should not be used on sensitive areas such as eyelids. The eyelids should be closed at all times during the procedure and may be covered with damp cotton pads.

5. The following areas are considered inappropriate for treatment: Skin tumor, moles, birthmark, angioma, lips, eyes, herpes, skin cancer, and liver spots.

Treatment Scheduel Table

Operating Instruction

1. Push in the movable ring of copper nozzle at the hand piece, and pull out the 8*5 size vacuum hose. Then push in the black plastic ring on the vacuum hose.
 

2. Put a drop of cream or milk lotion on the vacuum hose nozzle, push in the movable ring and insert in the vacuum hose to the limit.
 

3. Insert a cotton swab into the Diamond Head, then tight up the Diamond Head on the hand piece. Remove the cotton swab after every treatment.
 

4. Turn on the power switch.
 

5. Adjust the Vacuum intensity by Vacuum Regulator according to the following reference table, the intensity displays on Vacuum gauge and check with the client for comfort.
 

6. Use the incline area of Hand piece to contact with the skin surface. Proceed with a slow sliding motion. Do not place the hand piece at one spot for too long, doing so will cause harm to the skin.
 

7. Adjust the crystal flow rate by the Vacuum Regulator slowly from minimum to maximum. For commonly use, do not set the flow rate to maximum unless it is of necessity. This is for better comfort intensity.
 

8. Gently stretch the skin with thumb and finger and glide the Hand-piece 2 to 3 times over the area being treated. Then cross again in different directions to prevent streaking lines as in the reference picture. Brush strokes or polishing motions may be used in different sites.
 

9. After treatment, brush off all remaining dead skin with a soft brush and rinse with damp sponges or damp cool towel.
 

10. Allow skin to dry then apply desired skin product.
 

11. To clean the Diamond Head, use toothbrush or cotton swab damped with a little alcohol to wipe off the dirty impurity, and then use UV light or high temperature for sterilization.